Filter
Top Products
Hardware Setup SY-7IZB+
23
Step 16. Power-On by Keyboard Jumper (JP10)
You can choose to enable the Power-On by Keyboard or Mouse
function by shorting pin 1-2 on jumper JP1, otherwise, short pin 2-3
to disable this function.
Support Power-
On
by Keyboard
Enable Disable
JP10 Setting
Enable
Power-On by
Keyboard
function
(short pin 1-2)
Disable Power-
On by
Keyboard
function
(short pin 2-3)
Note: When using the Power-On by Keyboard function, please
make sure the ATX power supply can take at least 720mA load on
the 5V Standby lead (5VSB) to meet the standard ATX specification.
Step 17. Power On
You have now completed the hardware installation of your
Motherboard successfully.
1. Turn the power on
2. To enter the BIOS Setup Utility, press the <DEL> key while the
system is performing the diagnostic checks,
Note: If you have failed to enter the BIOS, wait until the boot
up sequence is completed. Then push the RESET button and
press <DEL> key again at the beginning of boot-up, during
diagnostic checks.
3
2
1
3
2
1