Filter
Top Products
BIOS Setup Utility SY-D6IBA
59
3-8.7 Onboard Parallel Ports
Onboard Parallel
Ports
Setting Description Note
378/IRQ7 Default
3BC/IRQ7
278/IRQ5
Onboard Parallel
Port
Disable
Choose the printer I/O
address.
ECP/EPP
SPP Default
ECP
Parallel Port Mode
EPP
The mode depends on
your external parallel
device that connects to
this port.
If [Parallel Port Mode] is set to [ECP] or [ECP/EPP] mode
3 Choose DMA3 Default
ECP Mode use DMA
1 Choose DMA1
If [Parallel Port Mode] is set to [EPP] or [ECP/EPP] mode
EPP1.7 Default
EPP Mode Select
EPP1.9
Select the correct EPP
operating mode of your
on-board parallel port.
(This setting should
match your parallel
device requirements.)
3-8.8 MULTI I/O ADDRESSES
Default settings for multi-I/O addresses are as follows:
Port I/O Address IRQ Status
LPT1
378 7 SPP
COM1
3F8 4
COM2
2F8 3
Warning: If a default I/O address conflicts with other I/O
cards such as sound card, you must change one of the I/O
addresses to remedy to this address conflict. (I/O addresses
can be adjusted from the BIOS Setup Utility)