Filter
Top Products
SY-P4I845PE Lite
Quick Start Guide
9
Hardware
Installation
FJ1 jumper (beside the AGP slot)
This jumper sets the default boot-up CPU frequency and the group of FSB frequencies that can be
selected in the BIOS.
CPU FSB 100MHz FSB
Auto Detect FSB
(Default)
133MHz FSB
FJ1 Jumper
Step 2. Configure Memory
This motherboard support PC2100 and PC2700, non-ECC and non-registered module.
The largest memory capacity possible is 2GB.
On this motherboard, DRAM speed can
be set independent from the CPU front side bus speed.
A maximum of 2 pcs.
Double-sided module can be used at the same time.
Memory Configuration Table
DDR1 DDR2 DDR3
Double sided Double sided None
Double sided Single sided None
Double sided Single sided Single sided
Single sided Single sided none
Note: System must have 533MHz FSB CPU to have PC2700 memory support.
Memory Settings
FJ1 jumper allows you to change the DRAM Frequency (DRAM multiplier) for this motherboard. This
setting will have a corresponding DRAM multiplier table which can be modified by using the “DRAM:
CPU multiplier “ option in the BIOS.
32 1
32 1
32 1