Filter
Top Products
SY-P4VDA Quick Start Guide
24
I cannot get the sound working on my system.
1. Check if the speaker wire is connected to the line out connector in the M/B.
2. Check if the speaker power is powered on.
3. Install the audio driver supplied on our driver disc.
4. Check BIOS setup if “onboard audio” is enabled.
5. If sound already installed, check our website for audio driver update.
The sound is working in my system, but when I play CD music from the CD-ROM, I
do not get any sound. What is wrong?
This is because the 3-wire audio cable from the CD-ROM to the on-board CDIN connector
in the M/B is not connected. See manual for location of CDIN.
The sound from my sound card is distorted when Windows start. What is wrong?
If you are using an ISA sound card, please make sure the IRQ needed for the sound card is
set to 'Legacy ISA' in the BIOS. In other word, if your ISA sound card takes IRQ5, then set
IRQ5 to 'Legacy ISA'.
The sound and everything else works fine except that the recorder and microphone do
not work. What is wrong?
1. Please go to sound properties and check if the recorder and microphone in the are
enabled.
2. Check if Microphone is ok.
Hard disk/FDD/ CD-ROM issue
My Western digital HDD is not detected during boot-up or No fix disk present.
Change the jumper settings to cable select or single or remove the jumpers.
Sometimes the system finds my CD-ROM, sometimes not.
1. Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the peripherals. If your
system has other peripherals connected, like CD-RW, extra HDD, etc. disconnect them.
When I boot up my new computer I got "floppy boot failure" and the LED on the
floppy stays on.
Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive side (don't