8 Section 2B. Installing the Software and Activating Your Device
Installing the Software and Drivers
To install and run the card and accompanying Sprint
SmartView software, you will need an available
ExpressCard slot or a PC Card slot and a CD-ROM or
DVD-ROM drive on your computer.
1. Insert the Sprint SmartView installation CD into
your computer’s CD-ROM or DVD-ROM drive.
The installer should run automatically. If the setup
program does not start, select
Start > Run and
enter d:\setup.exe, where
d is your CD-ROM drive
letter.
2. Follow the onscreen instructions using the Next
and
Back buttons to navigate through the
installation wizard, noting the following:
Ⅲ In order to continue with the installation, you
must click
Yes to accept the terms of the License
Agreement.
Ⅲ You will be asked to choose between the new
interface and the classic interface.
Ⅲ Please wait a few moments for the software and
drivers to install.
Ⅲ Click Finish to complete the installation. You may
be prompted to restart your computer to
complete the installation.
Proceed to “Inserting the Device” beginning on
page 10.
Note
Windows Vista and Windows 2000 users: You must
log in with administrative privileges to install the
software and drivers.
Windows XP users: You may need to log in with
administrative privileges, depending on your
Windows configuration.
As part of the installation process you may need to
restart your computer; save any open documents.
Important
Do not insert your card until you have installed
Sprint SmartView onto your computer or until
instructed to do so by Sprint SmartView.