Filter
Top Products
USB 2.0 High-Speed 2-Port Hub Controller
Datasheet
SMSC USB2512 32 Revision 1.92 (11-28-07)
DATASHEET
Chapter 5 DC Parameters
5.1 Maximum Guaranteed Ratings
Note: Stresses above the specified parameters could cause permanent damage to the device. This
is a stress rating only and functional operation of the device at any condition above those
indicated in the operation sections of this specification is not implied. When powering this
device from laboratory or system power supplies, it is important that the Absolute Maximum
Ratings not be exceeded or device failure can result. Some power supplies exhibit voltage
spikes on their outputs when the AC power is switched on or off. In addition, voltage transients
on the AC power line may appear on the DC output. When this possibility exists, it is suggested
that a clamp circuit be used.
5.2 Recommended Operating Conditions
PARAMETER SYMBOL MIN MAX UNITS COMMENTS
Storage
Temperature
T
A
-55 150 °C
Lead
Temperature
325 °C Soldering < 10 seconds
1.8V supply
voltage
V
DDA18PLL,
V
DD18
2.5 V
3.3V supply
voltage
V
DDA33,
V
DD33PLL,
V
DD33,
V
DD33CR
4.6 V
Voltage on any
I/O pin
-0.5 5.5 V
Voltage on
XTAL1
-0.5 4.0 V
Voltage on
XTAL2
-0.5 3.6 V
PARAMETER SYMBOL MIN MAX UNITS COMMENTS
Operating
Temperature
T
A
070°C
1.8V supply voltage V
DDA18PLL
V
DD18
1.62 1.98 V
3.3V supply voltage V
DDA33
V
DDA33PLL
V
DD33
V
DD33CR
3.0 3.6 V
Voltage on any I/O pin -0.3 5.5 V If any 3.3V supply voltage drops
below 3.0V, then the MAX
becomes:
(3.3V supply voltage) + 0.5