Star Micronics NP-415W Printer User Manual


 
28
20) Panel switch enable/disable:<< ESC c 5 n >>
Code : [1B ] h + [63] h + [35] h + n * [00nFF] h
Changes the FEED switch valid or invalid.
* “n” is only valid for LSB(b0)
* “n” bit has a following meanings
b0 Description
0 enable FEED switch
1 disable FEED switch
Default value of “n” is [00]h.
21) Print and “n” line feed:<< ESC d n >>
Code : [1B] h + [64] h + n * [00nFF] h
Prints the data in the print buffer and feeds paper by “n” lines.
* Beginning of a line is a print start position.
* If there is print data remained, line feed is activated for the same height of character.
22) Character code table select:<< ESC t n >>
Code : [1B] h + [74]h + n * [00n01]h
Selects either Japan code table or non-Japan code table.
Explanation : “n” value has following meaning.
n(Hex) character code table
00 Non-Japan character code table
01 Japan character code table
The default value of “n” is [S2-2] for DIP SW.
23) Printer status transmission :<< ESC v >>
Code : [1B] h + [76] h
Sends current printer status
* Status to be transmitted consist of 1 byte and the content is explained in the chart
below.
Value
bit Functions
0 1
0 paper near end paper present near end
1 platen open normal head open
2 paper end paper present no paper
3 head temp. abnormal normal Temp. high
4 cutter problem normal cutter problem
5 presenter problem normal presenter problem
6
paper remove sensor
information
no paper paper present
7 not defined
* Make sure that command is issued before transmission of print data.
(commands are stored in the input buffer and executed sequentially)
* Reception is available except in the buffer full status.
* The commands above are valid only for serial interface.
* Regarding DTR/DSR control, only one byte is transmitted after confirmation that the
host is able to receive data, that is DSR signal is in SPACE status. For XON/OFF
control, one byte is transmitted without confirmation of DSR signal status.
* For DTR/DSR control, if host is not in a receivable status, it waits until host can receive
data.
24) Inverted character set and reset :<< ESC { n >>