Filter
Top Products
Page 8
Note: You can always unpark paper, whether the printer is in “ready
mode” or “not-ready mode”.
Using the tear-off function
You can remove finished fanfold output without disturbing the current position of the
paper.
• Make sure that the printer is in ready mode, hold down the [READY] key and then hold
down the [PAPER] key. Keep both keys held down. The printer starts to feed the paper
through the printer.
• Release both keys. The printer automatically goes into not-ready mode.
• Tear off the paper, using the paper delivery selector’s tear-assist edge.
• Press the [READY] key again. The printer winds the paper back to its former position so
that printing can be resumed. The printer remains in ready mode.