Filter
Top Products
74
This mode can only be used with printing data that uses a 5 X 9 (2P-
1) font without decorations.
The limitations are listed below. The quality of the printed product
cannot be guaranteed if these limitations are removed and the unit
used.
[Limitations on the check high-speed printing mode]
• The only characters that can be printed are the 5 X 9 (2P-1) font
ANK characters.
• The double-sized width command cannot be used (the double-
sized height command may be used.)
• The bit image command cannot be used.
• Horizontal tabs cannot be used.
• The space setting command for the space between characters
cannot be used.
• The following limitations apply for the Y direction in the printing
area (value set with <ESC> “*”...)
1 As To=0 has been fixed as the starting point for the printing
area, the printing area command set with <ESC> “*” ....
Must be specified with Yo=YL=YH=0. (It will forcibly set
at 0 if it is at any other setting.)
2 The value of Dy must be a six-fold value.
As bi-directional printing in 6-pin units will be performed in this
mode, there are cases where the characters that have been
entered in a misaligned state will be printed in a wave-like style
and will not be able to be distinguished when the value of Dy is
anything other than a six-fold value as a joint will be
established within a single character for return printing.
Consequently, setting anything other than the six-fold value
must not be carried out. However, the printer will discard any
remainders from dividing by six and automatically correct it
into six-fold when any value other than six -fold has been set.
This command is only valid with the slip printer.
<FF>
0C
Print in page mode (only valid when in page mode)
This command can only activate the slip printer. In page mode, all
page data in the page area is printed, then the printer returns to line
mode. After all the page data is printed, the data in the page, the page
print area and the print direction are all initialized.
In addition, this command has no function in line mode.
CODE
HEX
FUNCTION