Filter
Top Products
– 17 –
[Paper out]
When the “paper out” detector senses the end of the paper, the printer stops
printing after printing a maximum of two more lines or on feeding the paper. The
printer will set the DTR to “MARK” and set the printer to OFF LINE five seconds
after a “paper out” condition is detected. To reset the printer after a “paper out”,
load a new roll of paper into the printer and press the OFF LINE switch to set the
printer ON LINE.
[Mechanical error]
Mechanical errors occur when the front cover is opened during printing and
printing stops or when the motor locks and printing stops. After the error occurs,
the printer outputs an X-OFF signal and stops printing. The printer sets the DTR
signal to “MARK” and sets to OFF LINE five seconds after a mechanical error
occurs. To reset the printer after a mechanical error occurs, close the front cover
properly and press the ON LINE switch. If a buzzer sounds and the ALARM lamp
flashes at this point, locate the cause of the error and turn the power off and then
back on to reset the printer.
Data buffer
Full
Near Full
Near Empty Empty
X-OFF X-ON
Remainder
256 bytes
256 bytes