Star Micronics TSP1000 Series Printer User Manual


 
19
ENGLISH
(3)Pull on the edge of the paper to
remove any slack and then push
down both sides of the printer cover
to close it.
Note: Make sure that the printer
cover is securely closed.
(4)If the printer cover is closed after
turning on the power, the cutter op-
erates automatically and the front
end of the paper is cut.
Note: If the cutter does not operate
after the printer cover is
closed, open the cover and
close it again securely.
(5)If necessary, attach the paper stop-
per to the paper cover as shown. The
output tray can hold up to 30 sheets
(width:80-82.5 mm, thickness: 80
120
µ
m, length: 50150 mm). For
paper with a different thickness or
for other sheet lengths, the limit is
10 sheets.
Note: When attaching the paper
stopper to the paper cover,
position the stopper accord-
ing to the length of the cut
paper. (Refer to the follow-
ing table.)
Paper length (mm)
Position 1 50 100
Position 2 100 120
Position 3 120 140
Position 4 140 160
Position 5 160 180
Position 6 180 200
Position 1
Position 2
Position 3
Position 4
Position 5
Position 6