Filter
Top Products
– 11 –
ENGLISH
Pause at a: HEX dump
Pause at b: sensor selection
Press ON LINE 1 short beep Reflecting sensor
Press FEED 2 short beeps Transmissive sensor
Pause at c: command mode selection
Press ON LINE 1 short beep Page mode
Press FEED 2 short beeps Line mode
3) Power + ON LINE + FEED switches
(Turn the power on while holding the ON LINE and FEED switches depressed.)
Approx. Approx. Approx. Approx.
2 sec. 2 sec. 2 sec. 2 sec.
1 short beep … 2 short beeps … 3 short beeps … 1 long beep … …
abcde
HEAD UP NO PAPER ERROR LEDs flash All LEDs
LED LED LED successively light up
lights up lights up lights up lights up
Pause at a: RAM backup cleared
Pause at b: feed function selection
Press ON LINE 1 short beep Top of Form disabled.
Press FEED 2 short beeps Top of form enabled.
Pause at c: sensor adjustment mode
Pause at d: no operation
Pause at e: clearing of all memory switches and test print
1 At e, release the ON LINE switch and FEED switch in 2 seconds
or less (all LEDs go off).
2 Press the ON LINE switch and FEED switch in 2 seconds or less,
and hold them depressed for at least 3 seconds (all LEDs light up).
3 Release the ON LINE switch and FEED switch.
4 The contents of all memory switches will be erased (all will be set
to 0).
After that, test print is carried out.
* If this process is interrupted midway, the printer will operate in
regular mode.
* After the memory switch settings are erased, the memory switches
must be set again, as appropriate for each model.