Filter
Top Products
Rev 0.00
―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications 5-12
<Printer status 4 Sensor Information (Sixth Byte)>
Bit Contents Status Model Compatability
“0” “1”
TSP800 TSP700 TSP600 TUP900
7 Fixed at 0 - - - - -
6 Not Used (Fixed at 0) - - - - -
5 Not Used (Fixed at 0) - - - - -
4 Fixed at 0 - - - - -
3 Paper end Paper No Paper OK OK OK OK
2
Paper Near-end (Inner
Side)
Paper No Paper
OK OK OK OK
1
Paper Near-end (Outer
Side)
Paper No Paper
No No No No
0 Fixed at 0 - - - - -
<Printer status 5 Sensor Information (Seventh Byte)>
Bit Contents Status Model Compatability
“0” “1”
TSP800 TSP700 TSP600 TUP900
7 Fixed at 0 - - - - -
6 Not Used (Fixed at 0) - - - - -
5 Not Used (Fixed at 0) - - - - -
4 Fixed at 0 - - - - -
3 Slip BOF Detector Paper No Paper No No No No
2 Slip TOF Detector Paper No Paper No No No No
1 Presenter Paper Detector No Paper Paper No No No No
0 Fixed at 0 - - - - -
<Printer status 6 ETB Counter (Eighth Byte)>
Bit Contents Status Model Compatability
“0” “1”
TSP800 TSP700 TSP600 TUP900
7 Fixed at 0 - - - - -
6 ETB Counter Bit-4 OK OK OK OK
5 ETB Counter Bit-3 OK OK OK OK
4 Fixed at 0 - - - - -
3 ETB Counter Bit-2 OK OK OK OK
2 ETB Counter Bit-1 OK OK OK OK
1 ETB Counter Bit-0 OK OK OK OK
0 Fixed at 0 - - - - -
(*) ETB Counter
This counter is the 5 bit ETB counter.
(It counts from 0 to 31. When ther counter overflows, it counts up from 31 to 0.)
This counter is incremented by 1 using the <ETB> command.
The ETB counter is initialized by the following commands. When doing so, ASB ETB status is cleared.
However, when initializing the ETB counter, ASB is not transmitted.
<ETB Counter Initialization Commands>
• <ESC> <RS> e n : ETB Counter Initialization
• <CAN> : Cancel print data and initialize commands