Filter
Top Products
– 19 –
8. CUTTER
Notes) If the cutter is not located at the home position when an error has occurred, it can be returned to
the home position by removing the cause of the error and turning the power off, then on again.
The cutter can also be returned to the home position by turning off the power, inserting a
screwdriver into the hole on the side of the cutter, then rotating the motor until the cutter is
returned to the position which is believed to be the home position.
Item Specification
Method Guillotine-type full cutting
Drive method DC motor
Installation Attached to the mechanism with screws
Supply Thickness of one sheet of paper: 60 to 85
µ
m
Minimum cutting length 25.4 mm (no presenter)
80 mm (equipped with presenter)
Life (standard paper) 300,000 times
Paper debris must be removed.
Error An error occurs if the cutter has not returned to the home position within
the specified time.