A SERVICE OF

logo

Open as PDF
next previous
Instruction Manual
3
Hardware Installation
1. Determine which bracket is required for your computer system. If you have a full-
prole computer system, attach the Full-prole bracket. If you have a low-
prole computer system attach the Low-prole bracket. To change the bracket
follow the below steps:
a) Using a small ratchet, or pliers (not included), remove both of the DVI-port stando
screws located on the outside of the bracket.
b) Using a Philips head screw driver (not included), remove the screw located next to
the internal side of the DVI-port on the circuit board.
c) You can now remove the undesired bracket by pulling the bracket away from the
PEXHDCAP60L.
Installation