Filter
Top Products
Instruction Manual
6
Testing the Console
To test that the console is working properly, perform the following steps:
1. Power up the rack console, and then turn on your computer.
2. Make sure the video image is centered within the screen area. Use the OSD controls
to adjust the image (see Panel controls and OSD functions) or press the Auto button
on the right hand side of the monitor.
Note: If the unit does not power up when the panel is pulled up, try pushing the soft
power on/o button on the right side of the monitor panel to power up the unit.
Note:You can adjust the horizontal and vertical position, contrast, and brightness to
better suit your video card and your personal preference.
Before you begin, make sure that power to all of the devices you will be connecting
to the console have been turned o. To prevent damage to your installation due
to ground potential dierence, make sure that all of the devices being installed are
properly grounded. Once all peripherals have been connected, please power them on.
Panel Controls and OSD Functions
The following controls are located on the bottom side of the the console monitor:
Controls Descriptions
Soft power on/o. Adjacent LED is lit when on.
Auto Auto-synchronize and scale down display to any valid factory
preset timings.
Up Press to scroll to the function you want to adjust.
Down Press to scroll to the function you want to adjust.
Menu To access the main menu. This button also acts as the Enter
button.