Filter
Top Products
Instruction Manual
11
CH Display:
Auto O: After you select a computer, the channel address and name of
the computer will appear on the screen for 3 seconds then
disappear automatically.
Always On: The channel address and name of a selected computer and/
or OSD status displayed on the screen all the time. The
non-volatile memory stores the CH Display setting.
Position: The position of the selected computer name and/or OSD status
displayed on-screen during operation. The actual display
position shifts due to dierent VGA resolution, the higher the
resolution the higher the display position. The non-volatile
memory stores the Position setting.
Upper Left, Upper Right, Middle, Lower Left, Lower Right.
Country Code for Sun: Sun keyboards of dierent languages have
dierent layouts. The KVM switch is able to emulate a Sun
keyboard for a specic language type or country such as
Arabic, Belgian, US, Yugoslavia, etc. Select the proper
country code that matches all of your Sun computers.
Please Note: The country code must be set prior to
powering up the Sun computer. Not performing this step
prior to power-up could cause the system to malfunction.
You can adjust the monitor resolution under this sub-menu. The following selections
are available: 1024x768, 1280x1024, 1600x1200, 1920x1440, widescreen: 1680x1050,
1280x720, 1366x768, 1920x1080 and “DDC2B Disable”.
Hot-key commands
Hot-key commands are short keyboard sequences used to select a computer, to
activate computer scan, etc. SV831DUSBAU interprets keystrokes followed by one or
two more keystrokes; a built-in buzzer generates a high-pitch beep for a correct hotkey
command, otherwise, one low-pitch beep for an error and the bad key sequence will
not be forwarded to the selected computer.
The short form hotkey menu can be turned on as an OSD function (<F4>:More\
Hotkey Menu) every time the left <CTRL> key is pressed twice.
NOTE: Left<CTRL>: denotes the Ctrl key on the left side of the keyboard