StarTech.com UNI3510BMU32 Computer Drive User Manual


 
Instruction Manual
3
Hardware Installation
WARNING! Hard drives and storage enclosures require careful handling, especially
when being transported. If you are not careful with your hard disk, lost data may
result. Always handle your hard drive and storage device with caution. Be sure that
you are properly grounded by wearing an anti-static strap when handling computer
components or discharge yourself of any static electricity build-up by touching a large
grounded metal surface (such as the computer case) for several seconds.
The UNI3510BMU32 allows for installation of both IDE and SATA 3.5” hard drives, using
interchangeable IDE and SATA boards. Please follow the installation steps below for
both types depending on which type you intend to install.
SATA Hard Drive
1. Open the enclosure by sliding the Hard Drive Tray out of the Metal Enclosure.
2. (Only required if the SATA board is not connected. If the SATA board is
connected proceed to step 4) Disconnect the IDE board by using a screw driver
to remove the 2 visibal screws on the smaller board pictured below, and gently
separate the boards from one another.