Chapter 13 Replacing Chassis Components 13-45
FIGURE 13-48 Removing the PCI Card Support
Note – Do not use the chassis cross brace as a handle.
Proceed to “Installing the PCI Card Support” on page 13-45.
Note – Do not operate the workstation without the PCI card support installed.
13.7.3 Installing the PCI Card Support
1. Open the chassis.
Refer to “Removing the Access Panel” on page 10-12
2. Identify where the PCI card support is to be installed.
See
FIGURE 13-46.
3. Install the PCI card support.
Align the lower pivot tab with the hole in the chassis bottom. Slightly depress the
upper pivot tab and slide it under the cross brace so that is clicks into place. See
FIGURE 13-49.
Pivot tab