Sun Microsystems 1500 Server User Manual


 
Chapter 11 Replacing the Motherboard and Associated Components 11-3
FIGURE 11-1 DIMM Location and Identification
Depending upon the configuration of your workstation, you can either add or
replace memory. In either case, the new DIMMs must meet the Sun workstation
requirements.
TABLE 11-1 lists the acceptable DIMM pair configurations.
When your workstation boots up, the OpenBoot PROM checks for compatible
memory modules. Refer to “OpenBoot PROM” on page 8-1 for additional
information.
If you are not removing an existing DIMM, proceed to “Installing DIMMs” on
page 11-8.
11.1.2 Removing DIMMs
1. Power off the system, open and position the chassis.
Refer to:
“Powering Off the Workstation” on page 10-4
TABLE 11-1 DIMM Configurations
Memory Installed DIMMs Configuration
512 MB memory 2 x 256MB DIMMs Standard
1GB memory 2 x 512MB DIMMs Standard
2GB memory 2 x 1GB DIMMs Optional
DIMM
DIMM0
DIMM1
DIMM2
DIMM3
DIMM gold edge
DIMM ejector levers (8)
DIMM slots (4)