Filter
Top Products
The following tests are run when the test command is executed:
hme register
MAC internal loopback
External loopback
100 Mbps PHY loopback
10 Mbps PHY loopback
If the test passes, you will see these messages:
Hme register test --- succeeded.
Internal loopback test -- succeeded
Transceiver check -- Using onboard transceiver -- Link up
passed
If the channel is not connected to a network, you will see the following error
messages:
Hme register test --- succeeded.
Internal loopback test -- succeeded
Transceiver check -- Using onboard transceiver -- Link down
Autonegotiation timeout
Check Cable or contact system administrator
Failed
selftest failed. return code = -1
Note - To test other channels of the adapter, you will need to execute the test
command separately on each channel.
7. After testing the adapter, type the following to return the OpenBoot PROM to
standard operating mode:
ok setenv diag-switch? false
8. Set the auto-boot? configuration parameter to true.
ok setenv auto-boot? true
9. Reset and reboot the system.
ok reset-all
Running Diagnostics Tests 43