Filter
Top Products
Chapter 3 Network Configuration 23
6. Shut down and halt the client system.
Use the shutdown command to display the OpenBoot (ok) prompt.
7. At the ok prompt, use the show-nets command to find the device path of the
GigaSwift Ethernet device.
The show-nets command lists the system devices. You should see the full path
name of the network device, similar to the example below. In this example, the
network@4 device is the Sun GigaSwift Ethernet adapter.
8. At the ok prompt, boot the client system using the full device path of the Gigabit
Ethernet device.
For example:
9. Proceed with the Solaris operating environment installation.
Refer to the Solaris Advanced Installation Guide for more information about installing
the Solaris operating environment over the network.
# shutdown -i0 -g0 -y
. . .
(shutdown command messages omitted)
. . .
ok
ok show-nets
a) /pci@1f,2000/pci@1/network@4
b) /pci@1f,4000/network@1,1
q) NO SELECTION
Enter Selection, q to quit: q
ok boot /pci@1f,2000/pci@1/network@4