Filter
Top Products
96 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • August 2004
3. At the ok prompt, set the auto-boot? configuration variable to false.
4. Set the diag-switch? parameter to true in order to see the diagnostic power-on
self-test (POST) messages.
5. Reset the system to activate these parameter changes.
6. Use the show-nets command to display the list of network devices on the system.
Among the list of devices, you should see the two interfaces specific to the Sun
GigaSwift Ethernet adapter you want to test, as shown in the following example.
Note – The preceding device paths are examples. The actual device paths on your
system may be different from the examples shown here.
7. Use the test command and the device paths found in Step 6, to test the adapter
when you use the FCode self-test.
The structure of the test command line that includes the following device
parameters:
Where:
s = 1000, 100, 10, auto
d = half, full, auto
c = master, slave, auto
ok setenv auto-boot? false
ok setenv diag-switch? true
ok reset-all
ok show-nets
a) /pci@1f,700000/network@2
b) /pci@1e,600000/pci@4/network@1
c) /pci@1e,600000/pci@4/network@0
q) NO SELECTION
Enter Selection, q to quit:
ok test device-path:speed=s,duplex=d,link-clock=c,promiscuous,