Filter
Top Products
30 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • August 2004
4. On the install server, install the GigaSwift Ethernet software to the client’s root
directory, as determined in Step 2.
Replace root-directory with the location of the client’s root directory.
Note – If the commands above do not work correctly, refer to the documentation
that shipped with your version of the Solaris Operating System.
5. Eject the Sun GigaSwift Ethernet Driver CD from the CD-ROM drive.
Note – Perform the following steps on the client system.
6. Shut down and halt the client system.
Use the shutdown command to display the OpenBoot (ok) prompt.
7. At the ok prompt, use the show-nets command to find the device path of the
GigaSwift Ethernet device.
The show-nets command lists the system devices. You should see the full path
name of the network device, similar to the example below. In this example, the
network@4 device is the Sun GigaSwift Ethernet adapter.
# cd /cdrom/cdrom0/GigaSwiftEthernet/Packages
# ls SUNWce*
SUNWcea SUNWceax SUNWced SUNWcedu SUNWcem
# pkgadd -R root-directory/Solaris_2.7/Tools/Boot -d . SUNWced SUNWcem SUNWcedu
# cd /
# shutdown -i0 -g0 -y
. . .
(shutdown command messages omitted)
. . .
ok
ok show-nets
a) /pci@8,600000/network@1
b) /pci@8,700000/network@5,1
q) NO SELECTION
Enter Selection, q to quit: q