Filter
Top Products
48 Sun GigaSwift Ethernet Adapter Installation and User’s Guide • February 2003
▼ To Specify Device Instances for the ndd Utility
Before you use the ndd utility to get or set a parameter for a ce device, you must
specify the device instance for the utility.
1. Check the /etc/path_to_inst file to identify the instance associated with a
particular device.
In the example above, the three GigaSwift Ethernet instances are from the installed
adapters. The instance numbers are in bold italics for clarity.
2. Use the instance number to select the device.
The device remains selected until you change the selection.
Noninteractive and Interactive Modes
You can use the ndd utility in two modes:
■ Noninteractive
■ Interactive
In noninteractive mode, you invoke the utility to execute a specific command. Once
the command is executed, you exit the utility. In interactive mode, you can use the
utility to get or set more than one parameter value. (Refer to the ndd(1M) man page
for more information.)
# grep ce /etc/path_to_inst
"/pci@1f,2000/pci@1/network@0"
2
"ce"
"/pci@1f,2000/pci@2/network@0"
1
"ce"
"/pci@1f,2000/pci@4/network@0"
0
"ce"
# ndd -set /dev/ce instance instance#