Filter
Top Products
316196601 • Revision: A Chapter 3 Virtual Operator Panel 19
Using VOP
Using VOP
There are two versions of VOP: 1) Customer and 2) Service.
Refer to the VOP documentation for information about how to download and
install these applications.
TABLE 3-1 is an example of these versions.
For the initial configuration, use a secure point-to-point connection and the default
IP address 10.0.0.1. Because all tape drives use the same default IP address,
connecting them to a switch for the initial configuration will cause problems;
unless you power the drives on and configure them one-by-one.
To use VOP for LTO4 tape drives, you need to launch a special file:
■ Windows: Launch the batch file (ltoVOP.bat)
■ Solaris/Linux: Launch the ltoVOP file (above the batch file)
TABLE 3-1 VOP Versions, Files, Documents, and Download Sites
Version Document Files Posted File Size
Customer 96179 VOP_CUST_REL_1.0.12.zip 05/28/2008 21:30 6055192
General_Instructions_Download 05/28/2008 21:42 47104
Document.txt 05/28/2008 21:56 173
Download Site: https://spe.sun.com/spx/control/Home
Service 96180 VOP_SVC_REL_1.0.12.zip 05/28/2008 22:12 7006234
General_Instructions_Download 05/28/2008 22:24 47104
Document.txt 05/28/2008 22:44 173
Download Site: http://dlrequest.sfbay.sun.com:88/
FIGURE 3-2 VOP Files and LTO Batch File
➪