Filter
Top Products
Chapter 2 Hardware Installation and Removal 17
■ Green OK LED goes to Standby.
2. Activate the NEM by pressing the Attention button, and the green OK LED goes
to Slow blink.
■ When all links to active blades have been made, the green OK LED goes to Solid
On.
■ Ready to Remove status shows Not Ready in the ILOM interfaces.
FIGURE 2-5 LEDs, Attention and Locator Buttons
The Attention button enables you to activate (if inserting) or prepare to remove (if
removing) a NEM during a hot-plug operation.
TABLE 2-3 NEM LED Status
Ready-to-Remove
LED
Color: Blue
Location: Top
Service Action
Required LED
Color: Yellow
Location: Middle
OK LED (Power, Attention,
and Connected)
Color: Green
Location: Bottom
Status
On Off Off Ready to remove
Off On Off Service attention required
Off Off Very slow blink Standby
Off Off Slow blink Connecting links to blades
Off Off On Links connected to blades
Ready-to-Remove
Service Action Required
OK LED (Power,
Locator button
Attention button
Locator LED
LED
LED
Attention, and Connected)