Filter
Top Products
Release: 1.0c 11 / 27
SupermicroSwitchWebGUIQuickConfigurationGuide
2.3.1 Changing the Management IP Address & Gateway
The management IP address and default gateway can be configured in the System Mgmt
Management IP page.
Fig 3: Management IP Page
IP Address Mode – For a static IP addresses use the Manual mode. To get an IP address
through DHCP, use the Dynamic mode.
IP Address – Use this setting to configure the IP address for static manual mode.
Subnet Mask – Use this setting to configure the subnet mask for the static manual mode.
Default Mgmt Gateway – The default gateway can be configured only for the SBM-GEM-
X2C, SBM-GEM-X2C+, SBM-GEM-X3S+, SBM-XEM-X10SM, SSE-X24S, SSE-X24SR,
SSE-X3348S, SSE-X3348SR, SSE-X3348T and SSE-X3348TR switches.
Note:
For the blade switches SBM-GEM-X2C, SBM-GEM-X2C+, SBM-GEM-X3S+ and SBM-XEM-
X10SM the management IP address and default gateway can also be configured from the CMM
management interface.
The management IP address and gateway of the switch are saved automatically into switch
NVRAM. Hence it is not required to save configuration in order to save the management IP and
gateway address.