Filter
Top Products
4
CHAPTER 1 FPS1000 SERIES SPECIFICATIONS
Model FPS1000 FPS1000 FPS1000
V/I -24 -32 -48
24 32 48
29 38.4 58
33 26 17.25
40 31 21
V1 (V)
V2 (V)
I1 (A)
I2 (A)
V1
V2
Fig. 1: Rated output current vs output voltage
Vout (V)
I1
Iout (A)
I2
Notes:
*1: For cases where conformance to various safety standards (UL, EN etc.) is required,
to be described as 100-240Vac (50/60Hz).
*2: At 100/200Vac, rated load and 25˚C ambient temperature.
*3: Not applicable for the noise filter inrush current less than 0.2mS.
*4: Measured with JEITA RC-9131A 1:1 probe, 20MHz B.W.
*5: From 85~132Vac or 170~265Vac, constant load.
*6: From No-load to Rated load, constant input voltage. Measured at the sensing point in Remote sense.
*7: Remote sensing can compensate up to 1V drop on each load wire.
*8: Inverter shut down method. Reset by AC voltage recycle or by On/Off control.
*9: Derate Maximum output power by 10% for input voltage less than 100V
RMS
.
*10 For FPS 1000-12/P(S), when used not with FPS-S1U or FPS-T1U
racks, an EMI suppressor clamp should be attached to the AC cable,
as close as possible to the AC inlet, to meet class B.
FPS1000
-12
12
13.2
66
72
1V
2V
3V
4A
5W
6
Input voltage / frequency range
(*1) ---
7
Maximum input current (at 100/200Vac)
A
8 ---
9 (*2) %
10 (*3) A
11 mS
12 (*5) ---
13 (*6) ---
14 (*4) mV
15 ---
16
PPM/°C
17 (*7) V
18 (*9) ---
19
Series operation
(*10)
---
20 ---
21 (*8) V
22 ---
23 ---
24 ---
25 ---
26 ---
27 ---
28 ---
29 ---
30 ---
31 ---
32 ---
33 ---
34 ---
35 ---
36 ---
37 ---
38 ---
39 ---
40 ---
41
---
42 ---
43 mA
44 Kg
45 ---
Rated output voltage
12
32
48
FPS1000 SERIES SPECIFICATIONS
FPS1000-12
FPS1000-32
FPS1000-48
Output voltage range
10.5~13.2
28.8~38.4
43~58
Output voltage set point
12+/-1%
32+/-1%
48+/-1%
Maximum output power
864
992
1008
Maximum Output Current (Refer to Fig.1)
72
31
21
85~265Vac continuous, 47~63Hz, Single phase
12.0/6.0
Power Factor (Typ)
>0.98 at 115/230V and maximum output power
Inrush current
Less than 40A
Efficiency (Typ)
84/86%
84/86%
85/88%
Hold-up time
20mS typical at 100Vac input, rated output voltage and less than 80% of rated load.
Maximum line regulation
0.40%
Max load regulation
0.80%
Output Ripple and noise pk-pk
200
250
300
Temperature stability
0.05% of rated Vout for 8hrs after 30min warm-up. Constant line, load and temperature.
Temperature coefficient
200
Remote sensing
Possible. Refer to Instruction Manual.
Parallel operation
Possible. Refer to Instruction Manual.
Possible. Refer to Instruction Manual.
Over current protection
105~125% of maximum output current. Refer to Fig. 1
Over voltage protection
31~34
41.5~45.5
62~66
Over temperature protection
Inverter shut down method, automatic reset.
Remote On/Off control
By electrical signal or dry contact. ON: 0~0.6V or short. OFF: 2~15V or open.
DC OK signal
Open collector signal. On when Vout>80+/-5% rated output. Max.sink current: 10mA
Over-Temp. warning
Open collector signal. Refer to Instruction Manual
AC fail signal
Open collector signal. Refer to Instruction Manual
Auxiliary power supply
11.2~12.5VDC. 0.25A Maximum output current.
Vout voltage trimming
Possible, via Vout Trim pin in the I/O connector. Refer to Instruction Manual.
Front panel indicators
AC OK, DC OK, DC FAIL
I
2
C Interface
Optional. Refer to Instruction Manual.
Operating temperature-models without IEC inlet
models with IEC inlet
0~50°C: 100% load. Derate 2%/°C, 50°C to 60°C, Derate 2.5%/°C, 60°C to 70°C.
Storage temperature
-30~85°C
Operating humidity
10~90% RH, no condensation.
Storage humidity
10~95% RH, no condensation.
Cooling
By internal Fans. Variable speed control.
Vibration
Built to meet ETS 300 019
Shock
Built to meet ETS 300 019
Conducted emission
EN55022B, FCC part 15J-B, VCCI-B
Radiated emission
EN55022B, FCC part 15J-B, VCCI-B
Applicable safety standards
UL60950-1, EN60950-1
Withstand voltage
Input-Output: 3000Vrms, 1min. Input-Ground:2000Vrms, 1min. Output-Ground:
500Vrms,1min.
Insulation resistance
More than 100Mohm at 25°C and 70% RH. Output-Ground: 500Vdc
Leakage current
Less Than 1.1mA at 230Vac
Weight (Typ)
2.0
Size (W*H*D)
127x41x290mm. Refer to Outline Drawing.
24
FPS1000-24
21.5~29
24+/-1%
960
40
81/83%
150
14.3~15.7
0~50°C: 100% load. Derate 2%/°C, 50°C to 60°C.
---