Filter
Top Products
Data Sheet: Supereta
TM
iQN Series –Single Output Quarter Brick
©2005-2006 TDK Innoveta Inc.
iQN 35V/6A/-0A9 Datasheet Issue 1.2 4/8/2008
℡
(877) 498
-
0099
11/15
Operating Information:
Over-Current Protection: The power
modules have current limit protection to
protect the module during output overload
and short circuit conditions. During overload
conditions, the power modules may protect
themselves by entering a constant current
limit mode with output voltage foldback.
Should the current tailed out during the short
circuit condition; the second level protection
will be tripped. In that case, the protection
circuit will latch the power module off. To
remove the module from the latched
condition, either cycle the input power or
toggle the remote ON/OFF pin providing that
over-current conditions have been removed.
The reset time of the ON/OFF pin should be
500ms or longer.
The iQN Supereta family also offers an
optional feature to allow non-latching 1-
second hiccup mode over-current protection.
Consult the TDK Innoveta technical support
for details.
Output Over-Voltage Protection: The
power modules have a control circuit,
independent of the main control loop that
reduces the risk of over voltage appearing at
the output of the power module during a
fault condition. If there is a fault in the main
regulation loop, the over voltage protection
circuitry will latch the power module off once
it detects the output voltage condition as
specified on the Electrical Data page. To
remove the module from the latched
condition, either cycle the input power or
toggle the remote ON/OFF pin providing that
over-voltage conditions have been removed.
The reset time of the ON/OFF pin should be
500ms or longer.
The iQN family also offers an optional
feature to allow non-latching 1-second
hiccup mode over-voltage protection.
Consult the TDK Innoveta technical support
for details.
Thermal Protection: When the power
modules exceed the maximum operating
temperature, the modules will turn-off to
safeguard the units against thermal damage.
The module will be latched off. To reset the
module from the latched condition, either
cycle the input power or toggle the remote
ON/OFF pin providing that the over-
temperature conditions have been removed.
The iQN Supereta family also offers an
optional feature to allow non-latching over-
temperature protection. Consult the TDK
Innoveta technical support for details.
Remote On/Off: - The power modules have
an internal remote on/off circuit. The user
must supply an open-collector or compatible
switch between the Vin(-) pin and the on/off
pin. The maximum voltage generated by
the power module at the on/off terminal is
15V. The maximum allowable leakage
current of the switch is 50uA. The switch
must be capable of maintaining a low signal
Von/off < 1.2V while sinking 1mA.
The standard on/off logic is positive logic.
The power module will turn on if pin 2 is left
open and will be off if pin 2 is connected to
pin 3. If the positive logic circuit is not being
used, terminal 2 should be left open.
An optional negative logic is available. The
module will turn on if pin 2 is connected to
pin 3, and it will be off if pin 2 is left open. If
the negative logic feature is not being used,
pin 2 should be shorted to pin 3.