Teac DA-88 Computer Drive User Manual


 
DA-88 quick ref.doc
10/14/97 7:27 PM
Page 1
© TEAC America, Inc., 1997 All rights reserved.
BASIC FUNCTIONS Software Version 4.01
Items marked SY are only available when the SY-88 is installed.
Function Display
LED
To Enter Function To Enter
Data
Remarks
1 Display ABS Time ABS
Hold DISPLAY +
--
2 Display H:M:S:F TC difference DIFF SY DISPLAY - -
3 Display Sub-Frame difference SY DISPLAY -
Press
to return to H:M:S:F display
4 Auto Offset Calculate & Store SY DISPLAY
and
Time code offset only
5 Display Generator Start Time & Enter
Data
GEN SY DISPLAY
or
-
6 Column by column Generator or
Offset time Setting
GEN
or
OFFSET
Hold
and
then
press DISPLAY
or
A period will start blinking in the Hours column, use
or
to enter hours. Press DISPLAY to move the
period to next column. After setting last column,
pressing DISPLAY will exit column setting mode
7 Display MEMO 1 & Enter data MEMO 1 DISPLAY
or
By pushing MEMO 1, point can be set on the fly
8 Display MEMO 2 & Enter data MEMO 2 DISPLAY
or
By pushing MEMO 2, point can be set on the fly
9 Display OFFSET & Enter data OFFSET DISPLAY
or
ABS time Offset entry in Frames only.
10 Display OFFSET & Enter Data SY DISPLAY
or
SMPTE T/C Offset entry in Frames, or when DISPLAY
is pressed again, in Sub-Frames.
11 Display PITCH & Enter data PITCH DISPLAY or VARI
or
-
12 Display Tape Time Code TC SY
Hold DISPLAY +
--
13 Display User Bits on tape SY
Hold
+ DISPLAY
-
TC LED will flash
14 Display Incoming Time Code SY
Hold
+
Display
- TC LED will flash. Press DISPLAY to exit.
15 Pull Up / Down mode setting SY
Hold
and press Fs
or
Press DISPLAY to exit
16 Display Pull Up / Down Status Any SY Press Fs button
-
Display will exit automatically