Filter
Top Products
MIU Installation, Operation & Diagnostics Edition: January 25, 1999 Page 2
1. STANDARDS
All Telenetics dial-up modems are designed to meet the following Standards:
USA: FCC Part 15, Class A and Part 68
Canada: DOC Standards CS-01, CS-02 and CS-03
CANADIAN DEPARTMENT OF COMMUNICATION NOTICE
NOTICE: The Canadian Department of Communications (DOC) label identifies certified equipment.
This certification means that the equipment meets certain telecommunications network protective,
operational and safety requirements. The department does not guarantee the equipment will operate to
the user’s satisfaction.
Before installing this equipment, make sure you are permitted to connect it to the facilities of the local
telecommunications company. You must install the equipment using an acceptable method of
connection. In some cases you may also extend the company’s inside wiring for single line individual
service by means of certified connector assembly (telephone extension cord). You should be aware,
however, that compliance with the above conditions may not prevent degradation of service in some
situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designed by the supplier. Any repairs or alterations made by a user to this equipment, or equipment
malfunctions, may give the telephone communications company cause to request the user to
disconnect the equipment.
For your own protection, make sure that the electrical ground connections of the power utility,
telephone lines and internal metallic water pipe system, if present, are connected together. This
precaution may be particularly important in rural areas.
Caution: Do not attempt to make electrical ground connections yourself, contact the appropriate
electric inspection authority or an electrician.
NOTICE: The load number (LN) assigned to each terminal device denotes the percentage of the total
load to the telephone loop used by the device, to prevent overloading. The termination on a loop may
consist of any combination of devices, subject to the requirement that the total of the load numbers of
all the devices does not exceed 100.