Filter
Top Products
Industrial Modem MIU56 User Guide
MIU56Robert Way Page 14 2/28/2003
M4 Speaker on during dial, answer, retrain or rate change
O1 Enter On-line state and force communication retrain (V.22bis and V.32bis only)
O2 Retrain, donÕt go on-line (V.22bis & V.32bis)
O3 Change line speed to 4800 bps (V.32 & V.32bis)
O4 Change line speed to 7200 bps (V.32 & V.32bis)
O5 Change line speed to 9600 bps (V.32 & V.32bis)
O6 Change line speed to 12000 bps (V.32 & V.32bis)
O7 Change line speed to 14400 bps (V.32 & V.32bis)
P Pulse dialling
Q0 Modem returns response codes
Q1 Modem does not return response codes
Q2 Modem does not return RINGING or response codes when answering
R9 9600 bps (locked terminal speed - no autobaud)
R14 14,400 bps (locked terminal speed - no autobaud)
R19 19,200 bps (locked terminal speed - no autobaud)
R28 28,800 bps (locked terminal speed - no autobaud)
R38 38,400 bps (locked terminal speed - no autobaud)
R57 57,600 bps (locked terminal speed - no autobaud)
R115 115,200 bps (locked terminal speed - no autobaud)
R230 230,400 bps (locked terminal speed - no autobaud)
Sn? Display value in S Register ÔnÕ
Sn=x Place ÔxÕ in S Register ÔnÕ
T Tone dialling
V0 Numeric response codes
V1 Verbal response codes
W0 CONNECT message reports the terminal speed
W1 CONNECT message reports the terminal speed
W2 CONNECT message reports the line speed
X0 Basic response codes (codes 0-4,8)
X1 Extended response codes (codes 0-5,8,10-12,30-40,60-62)
X2 Extended response codes (codes 0-6,8,10-12,30-40,60-62)
X3 Extended response codes (codes 0-5,7,8,10-12,30-40,60-62)
X4 Extended response codes (codes 0-7,10-12,30-40,60-62)
X5 Extended response codes (codes 0-7,10-13,30-40,60-62)
X6 Extended response codes (codes 0-5,7-8,10-13,30-40,60-62)
Zn Restore configuration profile n (n=0,1,2,3)
&B0 8 bit character length
&B1 9 bit character length
&B2 10 bit character length
&B3 11 bit character length
&B4 10 or 11 bit character length determined by autobaud
&C0 DCD signal always asserted
&C1 DCD signal responds to remote modem
&C2 DCD signal always on, pulses low on disconnect
&C3 DCD asserted during voice session
&D0 Ignore DTR
&D1 Return to Local command state if DTR goes low
&D2 Hangup & return to Local Com if DTR goes low, disable auto-answer until DTR
asserted
&D3 Initialise with values in &Y profile if DTR goes low
&F0 Restore factory defaults