Filter
Top Products
Argent Terminal Adaptor - User Guide
Version 1.1 Telstra Corporation Limited
Page 12/29 ACN 051 775 556
3.6.12 Observe that the ATA is ready and record the service details
When the above steps have completed successfully, and the configuration is downloaded.
There may be a 1-2 minute delay while the ATA activates software, after which the
decimal point on the Seven-Segment Display will be illuminated indicating that the unit is
now ready for EFTPOS transactions. (NOTE: If the EFTPOS terminal is not yet
connected the final display will be a flashing 3 - “No carrier from EFTPOS modem”).
After observing this write the following information onto the sticker at the bottom of the
unit:
• Argent EFTPOS service FNN:
FNN = FxxxxxxxxxxY (Argent Dedicated Service)
FxxxxxxxxxxT (Argent Test Service)
where xxxxxxxxxx is the 10 digit number of the OnRamp® 2 service.
• TEI = xx
• ATA Fault Reporting Number = Service Provider Helpdesk number
• Date of Purchase = dd/mm/yy
You must call your own Help Desk fault reporting number for any difficulties. This
number is supplied with the EFTPOS terminal.
3.6.13 Replace the ATA if Faulty on Arrival
If the ATA is faulty on arrival, see section 3.8 for warranty instructions.