Telstrat Argent Network Card User Manual


 
Argent Terminal Adaptor - User Guide
Version 1.1 Telstra Corporation Limited
Page 3/29 ACN 051 775 556
Table of Contents
1 INTRODUCTION 5
2 SCOPE 5
3 DESCRIPTION 5
3.1 Application 5
3.2 Definitions 6
3.3 Package Contents 6
3.4 Back Panel 7
3.5 Top Panel Seven Segment Display 8
3.6 ATA Activation Instructions 9
3.6.1 Prepare position 9
3.6.2 Connect ATA to NT1 9
3.6.3 Connect the EFTPOS terminal to ATA 9
3.6.4 Power-up the ATA 10
3.6.5 Adjust the Display Orientation of the ATA 10
3.6.6 Select the Required TEI Number 10
3.6.7 Observe D-Channel X.25 Call Progress For the First Call 10
3.6.8 Observe D-Channel X.25 call Progress For the Second Call 10
3.6.9 Observe the Software Download 11
3.6.10 Observe for Configuration File Errors 11
3.6.11 Observe for Failure to Connect 11
3.6.12 Observe that the ATA is ready and record the service details 12
3.6.13 Replace the ATA if Faulty on Arrival 12
3.6.14 Point-to-Point Protocol (PPP) Installation 13
3.6.15 Installing Dial-Up Network 15
3.6.16 Configuring Dial-Up Networking (DUN) 16
3.6.17 V.120 Setup 17
3.6.18 Connect the EFTPOS terminal 17
3.6.19 End to end test 17
3.7 ATA Maintenance 18
3.7.1 Check the Seven Segment display 18
3.7.2 Check that the Power is On 18
3.7.3 Restart the ATA 18
3.7.4 Perform a Cold Reboot on the ATA 18
3.7.5 Test the OnRamp
®
2 D-channel X.25 facility 18
3.7.6 Contact the Service Provider and Replace the ATA 18
3.7.7 Maintenance by Telstra 19
3.7.8 Customer Network Management (CNM) 19
3.8 Warranty 19
3.8.1 ATA faulty on arrival 19
3.8.2 ATA under Warranty - with Telstra Service Assurance 19
3.8.3 ATA under Warranty - without Telstra Service Assurance 19
3.8.4 ATA out of Warranty - with Telstra Service Assurance 20