Filter
Top Products
Step ➊
Remove Top Cover
Move the power switch to the OFF (0) position
and disconnect the power and interface cables.
Place the printer upside down and remove the
four rubber feet by pulling them out of the
mounting holes. Using a #1 Phillips screw-
driver, remove the four screws that secure the
top cover.
Carefully turn the printer right side up and lift
off the top cover. Use care not to damage the
cables leading from the top cover to the main
circuit board. Disconnect the cables leading
from the top cover to the main circuit board,
noting there positions.
Troubleshooting
980008-001 Rev. B
29