Filter
Top Products
24
Connections & Setup
SET THE SAT/CABLE CHANNEL (AUTOTUNING)
The next step lets you set the SAT/CABLE channel. When you set the
SAT/CABLE channel, you’re telling the monitor what channel to tune
to when you press the DIRECTV button on the remote.
Indicate which input you used to connect a satellite receiver, a cable
box or an HD receiver. If you don’t have one of these components
connected to the monitor, skip this step.
1. From the Channel menu (shown below), select Autotuning.
CHANNEL
1 Signal Type
2
Auto Channel Search
3 List and Labels
4 Autotuning
0 Go Back
2. From the Autotuning menu (shown below), select Set SAT/CABLE
Channel.
AUTOTUNING
1 Set VCR1 Channel...
2 Set VCR2 Channel...
3 Set DVD Channel...
4 Set SAT/CABLE Channel...
0 Go Back
3. From the Set SAT/CABLE Channel menu (shown below), point to
the choice that matches the way you have your satellite receiver,
cable box, or HD receiver connected to the monitor.
SET SAT/CABLE CHANNEL
1 Not connected
2 Channel 2
3 Channel 3
4 Channel 4
5 Video 1 Input
6 Video 2 Input
7 Video 3 Input
8 (S)VGA 2 Input
4. Press OK to select it.
Note that the (S)VGA2 input can be used
to connect an HD receiver so you can
receive high definition signals.