Filter
Top Products
8
Setup the Broadband Router
• Use the following IP address:
1 IP address: Please enter the fixed IP address.
2 Subnet Mask: Enter the Subnet mask.
3 Default Gateway: Enter the Gateway IP address.
• L2TP Settings:
1 User ID: Enter the L2TP username.
2 Password: Enter the L2TP password.
3 L2TP Gateway: Enter the Gateway.
4 Connection ID: Enter the Connection ID when necessary.
5 MTU: Enter the MTU size. (If the size is not specified, please leave the
default value at 1492.)
6 Connection Type:
• Continuous: The PPP-connection will always be active.
• Connect on Demand: The PPP-connection will establish when a
computer is accessing the Internet. The PPP connection will
disconnect when there is no more Internet traffic during the Idle
Time (minutes), entered in the field below.
• Manual: The PPP connection is established / disconnected
manually by clicking Connect / Disconnect.
JClick OK to proceed.
o Telstra Big Pond: not for Europe.
Now the quick setup wizard is finished.
J Click Apply to finish.
The router will reboot now. This will take about 60 seconds.
J Click OK when the reboot sequence is done.