Filter
Top Products
How to Set Up Your Computer to Use the Media Center
with a TV Tuner
11
If you have a cable TV set-top box, satellite, or other
set-top box that controls your TV signal, connect the
remote sensor control cable to the remote sensor and
position the end of it over the remote receiver on your
cable box.
1 Connect the IR receiver cable USB connector to an
available USB port on your computer.
2 Connect the IR remote sensor cable 3.5 mm
connector to the port on the IR receiver.
Sample IR receiver with cables attached
3 Position the end of the IR receiver cable over the
remote IR receiver window on your cable TV set-top
box or VCR.
4 Peel off the adhesive backing on the IR remote
sensor and mount the sensor within 5 inches of the
set top box or VCR.
5 Install batteries in the Windows Media Center
remote control.
For information on configuring the Media
Center and the Remote Sensor, refer to your
Electronic User’s Guide.
C1914-1.fm Page 11 Friday, September 19, 2003 1:00 PM