Filter
Top Products
2. SUPPLY SPECIFICATIONS EO10-33013B
(Revision Date: Apr. 24, 2008)
2.5 SPECIFICATION OF RFID TAG (for B-SX704-RFID-U2-EU/AU -R)
2-14
3) Roll-type RFID Supplies
When RFID supplies are to be rolled, roll hardness must be concerned.
Although it depends on the type of glue, tag, and backing paper, RFID-tag embedded labels tend to
stay rolled. Especially, when they are wound outside, a media jam error may occur. Unless otherwise
specified, it is recommended that the RFID-tag embedded labels be wound inside.
4) Sensor
When the transmissive sensor or reflective sensor is enabled, transmissivity or reflectivity of a label or
tag may vary at an RFID-tag embedded area depending on the pattern of an antenna or other factors.
In such cases, a manual threshold setting is required in the printer system mode. For details, refer to
the B-SX4T/5T Key Operation Specifications (EAA-1379).
5) Cutter
When an RFID label or tag is used in cut issue mode, care must be taken not to cut the antenna or the
IC chip of an RFID tag in order not to damage the cutter.
6) Static Electricity
When printing is performed in a place where humidity is low or under some specific conditions, writing
data on an RFID tag may fail due to static electricity generated by a label or a ribbon.