Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33047
2.7 Setting an Operating Environment
E2-17
2.7.1 Parameter Setting
While “<2>PARAMETER SET” is displayed on the LCD Message
Display, press the [PAUSE] key to enter the Parameter Setting Mode.
The Parameter Setting Mode contains the following sub menus. Each
time the [PAUSE] key is pressed, the sub menus are displayed
sequentially.
(1) Character code selection
(2) Character zero selection
(3) Baud rate selection
(4) Data length selection
(5) Stop bit length selection
(6) Parity selection
(7) Flow control code selection
(8) LCD language selection
(9) Auto forward wait selection
(10) Control code selection
(11) Strip wait status selection
(12) FEED key function selection
(13) KANJI code selection
(14) EURO code selection
(15) Auto print head check selection
(16) Centronics ACK/BUSY timing selection
(17) Web printer function selection
(18) Input prime selection
(19) Ribbon near end selection
(20) Expansion I/O interface selection
(21) Plug & Play selection
(22) Label end/ribbon error selection
(23) Pre-strip selection
(24) Reverse feed speed selection
(25) Maxi code specification selection
(26) Keyboard interface selection
(27) Strip motor torque selection
(28) Print head applied current table selection