Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33059
2.4 Loading the Media
E2- 5
2.4 Loading the Media
(Cont.)
5. Put the media on the Supply Shaft.
6. Pass the media around the Damper, then pull the media towards the
front of the printer.
7. Align the projection of the Supply Holder with the groove of the
Supply Shaft, and push the Supply Holder against the media until the
media is held firmly in place. This will centre the media
automatically.
Then turn the Locking Ring clockwise to secure the Supply Holder.
8. Place the media between the Media Guides, adjust the Media Guides
to the media width, and tighten the Locking Screw.
9. Check that the media path through the printer is straight. The media
should be centred under the Print Head.
NOTE:
D
o not ove
r
-tighten the Lockin
g
R
ing of the Supply Holder.
Supply Shaft
Su
pp
l
y
Holder
G
r
oo
v
e
Damper
Locking Ring
Projection
Media
Media Guide
Supply Holder
Media Guide
Print Head
Locking Screw
Media
Damper
Media
In case of a label rolled with
the print side facing inside.
In case of a label rolled with
the print side facing outside.