Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33059
2.9 Setting an Operating Environment
E2-22
2.9.1 Parameter Setting
(Cont.)
(11) Solenoid Type Selection
This parameter is to choose the solenoid type that is actually installed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the solenoid type, press the [PAUSE] key.
(12) Ribbon Saving Function Selection
This parameter is to choose whether to activate the Ribbon saving
function or not.
This function enables reducing the ribbon loss caused by taking up
unused ribbon during non-print areas.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the ribbon saving function, press the [PAUSE] key.
<2>PARAMETER SET
RBN SAVE ON (TAG)
[RESTART]
[FEED]
RBN SAVE ON (LBL)
Activated (When the head lever is set to
“
(
1
)
LABEL”.
)
RBN SAVE ON (TAG)
Activated (When the head lever is set to
“
(
2
)
TAG”.
)
RBN SAVE OFF
Not activated
NOTES:
1. Ribbon saving option should be
selected according to the head
lever position. Incorrect setting
may disable the proper ribbon
saving function.
2. The ribbon saving function is
activated when there is a 20-mm
or more non-print area in the
media feed direction.
3. Ribbon saving is enabled up to 4
areas per media.
<2>PARAMETER SET
SOLENOID TYPE1
[RESTART]
[FEED]
SOLENOID TYPE2
TDS-16A (Stronger pull force type)
(Insulation tape is black.)
SOLENOID TYPE1
TDS-12C (Insulation tape is blue.)
NOTE:
I
mproper setting of the solenoid type
may disable the ribbon saving
f
unction.