Filter
Top Products
2. PRINTER SETUP
ENGLISH VERSION EO1-33036
2.7 Loading the Media
E2-10
2.7 Loading the Media
(Cont.)
Build-in rewinder mode
When the Rewinder Guide Plate is attached, the Take-up Spool can be
used as a Built-in Rewinder to take up the printed media.
(1) Remove the two Black Screws to detach the Front Plate.
(2) Attach the Rewinder Guide Plate to the Strip Plate with the SMW-
4x8 sems screws.
(3) Insert the media under the Rewinder Guide Plate.
(4) Wind the media onto the Take-up Spool and fix it in position with
the Take-up Clip.
(5) Rotate the Take-up Spool counterclockwise a few times to remove
any slack in the media.
(6) Set the Selection Switch mounted on the Rewinder Assembly to
REWINDER
position.
NOTE:
B
e sure to set the Selection
Switch to REWINDER position.
ADJUSTMENT:
I
f the media skews when using
the Built-in Rewinder, turn the
A
djustment Knob of the
R
ewinder Guide Plate to correct
the media feed. Clockwise turn
moves the Rewinder Guide Plate
f
orward and counter-clockwise
moves it backward.
When the media skews to the
right:
L
oosen the SM-4x8 screw, turn
the Adjustment Knob clockwise,
and then tighten the SM-4x8
screw when the Rewinder Guide
Plate is positioned correctly.
When the media skews to the left:
L
oosen the SM-4x8 screw, turn
the Adjustment Knob counter-
clockwise, and tighten the SM-
4x8 screw when the Rewinder
Guide Plate is positioned
correctly.
Rewinder
Guide Plate
SM-4x8 Screw
Adjustment Knob
Front Plate
Black Screw
Rewinder
Guide Plate
SMW-4x8 Screw