Toshiba B-SX5T-TS25-QM-R Printer User Manual


 
2. PRINTER SETUP ENGLISH VERSION EO1-33059
2.9 Setting an Operating Environment
E2-30
2.9.1 Parameter Setting
(Cont.)
(26) Label End/Ribbon End Selection
This parameter is to choose a printing process when a label end or ribbon
end is detected.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting a Label End/Ribbon End type, press the [PAUSE] key.
(27) Pre-Strip Selection
This parameter is to choose whether to activate the Pre-strip function.
When this parameter is set to ON (Available), the top edge of a label is
separated (pre-stripped) from the backing paper before the label is printed.
This function is intended to make the strip issue easier in case the labels
are hard to strip due to the label intensity, adhesive power, or the printing
speed.
When “<2>PARAMETER SET” appears, press the [PAUSE] key until
the following display appears.
Use the [FEED] or [RESTART] key to select a desired option.
After selecting the Pre-strip function, press the [PAUSE] key.
<2>PARAMETER SET
LBL/RBN END TYP1
LBL/RBN END TYP1
LBL/RBN END TYP2
[RESTART]
[FEED]
TYPE1: When a label/ribbon end is
detected in the middle of printing,
printing is immediately paused.
TYPE2: When a label/ribbon end is detected
in the middle of printing, the printer prints the
half-finished label as far as possible, and
stops when the next label is at the home
position.
<2>PARAMETER SET
PRE PEEL OFF OFF
PRE PEEL OFF OFF
PRE PEEL OFF ON
[RESTART]
[FEED]
Unavailable
Available