Toshiba B-SX5T-TS25-QM-R Printer User Manual


 
7. SUPPLY SPECIFICATIONS ENGLISH VERSION EO1-33059
7.1 Media
E7- 2
7.1.2 Detection Area of the Transmissive Sensor
The Transmissive Sensor is movable from the centre to the left edge of media.
The Transmissive Sensor detects a gap between labels, as illustrated below.
<Label>
<Tag paper with square holes>
N
OTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified media.
2. The media length specifications for use of the cutter are:
*1: When issuing a label using the swing cutter, label length should be 35.0 mm – (Gap length/2).
3. When marking black marks on the label rolls, they should be marked at the gaps.
4. “On the fly issue” means that the printer can feed and print without stopping between labels.
5. There are restrictions in use of the media which is narrower than 50 mm. For details, refer to TOSHIBA TEC
service representative.
6. The ratio of a label length to a gap length must be a minimum of 3 to 1 (3:1).
7. When using a label stock in cut mode, be sure to cut the gaps. Cutting labels will cause the glue to stick to the
cutter, which may affect the cutter performance and shorten the cutter life.
Sensor position
A
rea to be detected.
Centre of media
Print side
Min. 12 mm
Label
Gap
Label
Min. 2.0 mm
(Min. 6.0 mm when using
the cutter module.)
Sensor is movable
within this range.
Media feed direction
Sensor position
Centre of media
Min. 12 mm
Media feed direction
Min. 2.0 mm
Sensor is movable
within this range.
Square holes
(Round holes are not acceptable.)
Print side
N
OTE:
R
ound holes are not acceptable.