Filter
Top Products
8-5
EO1-33015
8. LOADING THE MEDIA
8. LOADING THE MEDIA
Strip type:
1 Strip labels from the backing paper for about 200-mm long from the top edge of the label roll.
2 Lower the backing paper release bar.
3 Pass the backing paper between the strip roller and the backing paper holder. After taking up
any slack of the media, set the backing paper release bar in position.
Fig. 8-8
Media (Backing Paper)
Backing Paper Holder
Backing Paper Release Bar
9. Turn the head lever to the proper position depending on the used media. (Refer to Fig. 7-1)
1: Labels or thin tag paper
2: Thick tag paper
CAUTION: When using labels ensure that the head lever is set to position
1
.
10. Close the top and right side covers.