Filter
Top Products
12-2
EO1-33015
12. GENERAL MAINTENANCE
12.1 CLEANING
7. Turn the pinch roller lever to the right.
8. Remove the white screw and detach the ribbon end sensor plate.
NOTE: When installing the ribbon end sensor plate, be sure to fit both studs in the notches of the ribbon
end sensor plate.
9. Remove the pinch roller block, then clean the roller belt and feed roller with cloth moistened by
alcohol.
Fig. 12-2
Stud
Stud
Pinch Roller Lever
White Screw
Ribbon End Sensor Plate
Fig. 12-3
Pinch Roller Block
Roller Belt
Feed Roller
10. Reassemble the pinch roller block in the reverse order of removal.