Filter
Top Products
APPENDIX 1 SPECIFICATIONS
EO1-33030
A1.2 Media
A1- 2
A1.2 Media
Please make sure that the media that will be used is approved by TOSHIBA TEC. The warranty does not apply
when a problem is caused by using media that is not approved by TOSHIBA TEC.
For information regarding TOSHIBA TEC approved media, please contact a TOSHIBA TEC service
representative.
A1.2.1 Media Type
Cut form and fanfold paper can be used. The table below shows the size and shape of the media available for this
printer.
Cut Form
Unit: Inch + (mm)
Item Cut Form
A: Media pitch 4.7 – 15.7 (120 – 400)
D: Media width 1.3 – 4.2, *4.3 (33 – 106, *109)
E: Gap/Black mark length 0.1 (3)
G: Effective print width 0.9 – 4.1 (22 –104)
H: Effective print length Max. 15.4 (390)
I: Non print area 0.3 (6.4)
M: Black mark prohibited area for the auto feed function 1.0 (26)
N: Black mark position for the auto feed function 1.4 (35)
*: When the paper guide unit is removed.
Fanfold Paper
A
D
E
G
I
H
M
E
N
Feed Direction
Max. 2”
(
50 mm
)
Black mark for the
Auto Feed Function
(
on the reverse side
)