Filter
Top Products
2. PRINTER SETUP ENGLISH VERSION EO1-33088
2.7 Loading the Media
E2-11
NOTES:
1. When issuing labels without
removing them from the backing
paper, it is not necessary to pass
the media through the Strip Block.
2. When the media is correctly set,
the backing paper is supposed to
be pinched by the Platen and the
Strip Feed Roller as shown below.
3. If the peel-off issue is performed
under intense light, the strip sensor
may not correctly detect the
presence of a printed label on the
s
trip shaft. In this case, reduce the
intensity of the light or fit the
Shade Plate to the Strip Block as
shown in the figure.
Shade Plate
Strip Feed Roller
2.7 Loading the Media
(Cont.)
Strip mode (Option):
When issued in the strip mode, labels are automatically removed from the
backing paper each time a label is printed.
• How to set the media
When issuing labels in the strip mode, set the label in the following
procedure:
1. Load the media as described on the previous pages.
2.
Open the Strip Block by pulling it out.
3. Remove enough labels from the leading edge of the media to leave 20
cm of backing paper free, and insert the top edge of the backing paper
into the media slot in the Strip Block.
4. Close the Strip Block and Top Cover.
Strip Block
Strip Plate
Label
Backing Paper
Platen